This Mig Mag Welder can operate in manual as well in automatic/ synergic mode and is complete with three torches ever assembled and ready to use, i.e.:

• one torch spool gun for aluminium wire, complete with wire pulling roller (so to keep the wire excursion very short and avoid the problems caused by the AL wire softness).


• two torches for traditional welding and brazing (welding on galvanized sheets).
  Time consuming replacement of wire coils is completely eliminated.
  The generator can perform all types of welding on the new panel materials provided by modern building techniques (-Steel-Stainless Steel - Aluminium
  Brazing CuSi3).
  This generator is designed to offer maximum flexibility and simple use also to non-experts.
  In the electronic card are stored all welding parameters to the main wire types to best synergic functioning.

Double display for best parameter viewing Modalità di saldatura 2T, 4T, puntatura e pulsata Digital encoder for parameters setting Parameters menu : - Wire speed - Motor speed slope up - Spot time - Pause time - Pre e post gas - Burn back time - Manual/Synergic key - Material, diameter e gas keys - Thermal failure led - Spool Gun remote control with potentiometer

• Cod. 09000100 - Magnesium-Aluminium Wire coil (ø 0,80 kg. 0,50)
• Cod. 09000200 - Silicium Aluminium Wire coil (ø 0,80 kg. 0,50)
• Cod. 09000400 - Brazing wire coil Cu/Si3 (ø 0,80 kg. 5,0)
• Cod. 09000500 - Wire coil SG2 (ø 0,80 kg. 15,00)

• Cod. 09004000 - Steel wire feeder nozzle (pack à 5 pcs)

• Cod. 09004100 - Aluminium wire feeder nozzle (pack à 5 pcs)

• Cod. 09003000 - Pressure reducer

• Cod. 09003100 - ø mm 0,9Z - mm 1,2L
• Cod. 09003200 - ø mm 0,8Z - mm 1,0L
• Cod. 09003300 - ø mm 0,8AL - mm 1,0AL
• Cod. 09003400 - ø mm 0,6Z - mm 0,8Z
• Cod. 09003500 - ø mm 0,6AL - mm 0,8AL
• Cod. 09003600 - ø mm 0,6L - mm 0,8L
• Cod. 09003700 - ø mm 0,9Z - mm 0,9Z

Z= to animated wire
L= to normal steel wire
AL= to aluminium wire